MX-3.com

This one.

http://cgi.ebay.ca/ws/eBayISAPI.dll?Vie ... %3AIT&rd=1

Yes that can be used on the K8. But on another note if you search on here you will find this question answered a million times over. There is even a "how to" at the beginning of the forum that discusses the different options you can use and what to look for when making your own cai.

Nate

Hopefully you noticed the shipping cost to Canada?

On the same note, you are right it has been answered but the guy has a point on this kit. I've never seen it and the item only describes it as mx3 not 4 cyl or V6. Looking at it you would assume it would fit but you know what you do when you assume.

Looks like a great kit actually and if it was in the UK I'd buy it but i'm not paying that for shipping!

Actually the link says its for the sohc 4 cly only. But i still think it would work because an intake it nothing more than piping and couplers. Pretty simple. It has the two nipples needed to replace everything on the stock intake. As long as it is the right diameter i cant see any reason why it wouldnt work.

Nat

you could probably get an integra intake and save urself like 20 bucks

FITS: MAZDA MX3 (93-97) 4CYL SOHC ENGINE MODEL ONLY

read the website before you ask a question.

Integra intake is the easiest way to make cai takes like 2 hrs for someone who doesnt know what they are doing u just need 2 couplers to put maf in the middle of it

hoodzy has great write up for it!

now that i look it looks pretty damn close to my intake set up thing is the smaller piece, looks a bit too small and i'm thinking wont fit to go around the battery

i screwed mine up and its super tight around the batter, which causes my pipe to not be straight in line with the tb.. so i would say no it wont fit.. i had quite a bit chopped off my smaller piece that i can recall