aaaaahhhhhhhhhhhhh.... CV joint
aaaaahhhhhhhhhhhhh.... CV joint
i think i snapped my CV joint... i did a burn out while turning and i hear a CLunk! then when its in gear and engage the clutch i hear clunk clunk clunk.. previously i had that clunking while going up and down the driveway. thats why i think its the CV joint
92 RS: BPT, evo front mount, custom 2.5 in IC pipes, apex-i SAFC- II, GReddy type-RS BOV, rear disc swap, GTX front strutbar, oem GS lower rear tie bar, Topspeed1 axle back exhaust, 15" TSW wrapped in yokohamas, power window swap. NOT INSTALLED: GReddy turbo timer and CS downpipe.
-
Casino
- Regular Member
- Posts: 779
- Joined: April 20th, 2002, 2:01 am
- Location: Sudbury Ontario Canada / windsor
Re: aaaaahhhhhhhhhhhhh.... CV joint
<blockquote><font size="1" face="Verdana, Arial">quote:</font><hr>i did a burn out while turning and i hear a CLunk <hr></blockquote><p>hey turns out when you do stuff like that things break lol.
ya it could be the cv joint
ya it could be the cv joint
Re: aaaaahhhhhhhhhhhhh.... CV joint
doh! 225 outta my pocket... 
and it turns out the boot on the other side was torn so its gonna be 350 all together!
and it turns out the boot on the other side was torn so its gonna be 350 all together! 92 RS: BPT, evo front mount, custom 2.5 in IC pipes, apex-i SAFC- II, GReddy type-RS BOV, rear disc swap, GTX front strutbar, oem GS lower rear tie bar, Topspeed1 axle back exhaust, 15" TSW wrapped in yokohamas, power window swap. NOT INSTALLED: GReddy turbo timer and CS downpipe.
-
Sonicxtacy02
- Senior Member
- Posts: 2053
- Joined: January 1st, 2001, 2:01 am
- Location: Woodbridge, VA, USA
- Contact:
Re: aaaaahhhhhhhhhhhhh.... CV joint
lol@ $350 to repair any TWO items on an mx-3. You got off easy bro!
Shaun Newman
SOLD 1994 Blaze Red GS/ SOLD 1994 Chaste White GS-R
SOLD 1994 Blaze Red GS/ SOLD 1994 Chaste White GS-R
-
loudsubz
- Regular Member
- Posts: 239
- Joined: November 24th, 2001, 2:01 am
- Location: Mississauga
- Contact:
Re: aaaaahhhhhhhhhhhhh.... CV joint
**** for $350 you could buy the tools and do it yourself.<p>Air tools rock, Id never use hand ones again.