WTB 5 Spd Shift clip/bolt/harness/mount

[joshcallahan]

I need the part that actually holds the shifter to the car, so it doesn't fall through the floor of the car, I believe it is a rubber piece or something to that effect, Any info would also be appreciated!

[jimishadow]

drill a hole through both steel pieces and use a bolt loc washer and nut,did it 12000 miles ago,as long as the rubber is good and the only trouble is it falling down,this will do it,just take off console hold up shifter and drill through both pieces,put bolt in.

[joshcallahan]

That rubber piece is the problem i think it's not there...You have anything laying around that I could use? OR know where I could find one?

[Dracos]

yeah, i have the same problem and i have tried getting it welded about 3 times now and the welds just keep breaking