Need Clutch Hydraulic Line Diagram/pic

[mazdags94]

Anyone have a pic or diagram for the V6 clutch hydro lines? My SS line comes up short to the line coming out of the master cyl and I need to see if the lines are run correctly.

Thanks in advance.

[Newfie_dan]

there should only be 1 line for the clutch slave cylinder and thats to the clutch reservoir.

[mazdags94]

Sorry. What I meant to say is that since the clutch line (one line from reservoir to slave) has multiple sections, I wanted to see how each section was routed. There is a section that runs from the slave to the flex line, then the flex line to another hard line which connects to the CMC, and finally one last line that connects the CMC to the brake MC. I am buttoning up my MTX swap and I just mounted the CMC and purchased the steel line from the CMC. A line from the slave cyl does exist and connects to a SS flex line. However, the flex line is not long enough to reach the steel line that goes to the CMC (it is about 4-5" short). Here is the best way I can describe my prblem without a picture:

[SLAVE]-----------/----[flex line]----/ [gap here] /---[steel line]-----[CMC]--------[BMC]

The tranny came from a 93 PGT so would the slave cylinder steel line be bent a different way preventing it from being compatible with the MX-3? Or maybe the bracket holding the line is mounted in a different place?

I just want to see a snapshot of someone's clutch line setup so I can compare to mine (just to see what's different). Something must be different otherwise it should line up just fine.