Rewire Millenia MAF to fit my MX3 -92

[lerutis]

Hi !

I've been searching like a crazy mofo and i think i found what i'm looking for. I'm wondering if anyone have tried this out or have any other info before i do this.

So what i found is this wire diagram on mx6.com

(Looking at the VAF connector from the top (That being told by the snap connector on top) Left to Right:
1) White/Black ----- Orange/Blue (White for the Saturn IAT)
2) Black ----- Black/Yellow (Black for the Saturn IAT)
3) Black/Red ----- Pin 3 on your Connector for the MAF (this is also With the Snap on top going from Left to Right, also easier to identify as the Middle Plug for the VAF Connector)
4) Green ----- Not Used
5) Red ----- Pin 2 On your Connector for the MAF (this is also With the Snap on top going from Left to Right, also easier to identify as the Middle Plug for the MAF Connector)

I just google on the IAT because i didnt know what it was, but what i've understand is that on K8 VAF JE50 this is built in?