REAR TAIL LIGHTS FUSE BLOWING!!

This forum is for discussion of topics relating to MX-3 lighting such as Headlights, Tail lights, Accessory Lights, Interior Lights, Etc. For example, Rear Euro Altezza Style Tail lights, Headlight units, LED's, HID's, Bulbs, Interior lights, Neons, Strobes, Auxillary Lights/Fogs or anything filament and gas discharge related.
Also anything dealing with the elctrical system.
User avatar
umcamara
Supporting Member
Posts: 1892
Joined: June 12th, 2007, 3:15 am
antispam: No
Location: Winnipeg, Manitoba, Canada

Re:

Post by umcamara »

2fazed wrote:I had the same problem with a few different Mazda's. Like the dimmer wire, when putting aftermarket stereos in. The problem was using the stock ground wire. I had to make a new one. Maybe if you disconnected the stereo, and tried it, see if it makes a difference.
That's usually caused by using the car's dimmer wire as the radio's ground. This is a common mistake that people make, because the wire shows ground until you turn on the parklights. Then it's positive, and shorts out through the deck.
'96 Silver Stone Metallic MTX RS
'98 BMW 328is M-Tech

Feedback Thread
krazysteve
Junior Member
Posts: 20
Joined: November 17th, 2007, 5:05 pm
Location: Chesterfield England

Re: REAR TAIL LIGHTS FUSE BLOWING!!

Post by krazysteve »

Thanks for all your input, removed the radio today, found what looked like a spiders web behind it. Lights now work fine, will have to rewire the radio :wink: , may even treat it to a new one :!:
Post Reply

Return to “Electrical & Lighting”