Mx-3 ZE On 4.11:1 Tranny = Slower?

Hayata · Post by **Hayata** » November 11th, 2006, 1:38 pm

kool thanks well 800~500rpm difference is ok i guess. im always on the highway so i need to find a way to reduce rpms. any other way??? custom gear ratios???[/code]

nolig2278 · Post by **nolig2278** » April 15th, 2007, 10:38 pm

so which trannies have a 4.11 and which have a 4.39?

just to confirm as I am a bit confused the 4.11 will have a lower rpm at higher speeds than the 4.39?

Which ratio gets you about a 50 rpm per mile ratio in 5th? Basically if your doing 4000 rpm your going 80 mph, 3000 = 60 mph.

I am thinking of just changing the 5th gear as that is not a difficult swap and it would be to save gas mileage. I tend to drive between 80 and 90 mph. It would also be a little quieter and easier on the engine. I have a bpt so power is not a concern.

thanks

Nd4SpdSe · Post by **Nd4SpdSe** » April 16th, 2007, 5:48 pm

Basically the lower the number, the taller your gears, which means you rev lower, as well, also increasing your top speed

4.38:1 - Probe & Mx-3
4.11:1 - Mx-6 & 626

None of which you can use since you have BPT

nolig2278 · Post by **nolig2278** » April 16th, 2007, 7:29 pm

Why couldn't a BPT use the gears mentioned above?

I have a 1.8 dohc protege tranny on my car now which is a G series. The same G series can be used on the cars mentioned above from what I have read.

Nd4SpdSe · Post by **Nd4SpdSe** » April 16th, 2007, 7:42 pm

Internals, maybe, I dont know, but externally to bolt the gearbox to the motor, not going to happen.

http://mx-3.com/phpbb2/viewtopic.php?t= ... cad95d5043

nolig2278 · Post by **nolig2278** » April 16th, 2007, 8:01 pm

its the internals i am looking for and I believe the 4cyl 626 would be a match to fit.

Nd4SpdSe · Post by **Nd4SpdSe** » April 16th, 2007, 8:06 pm

There's some info you can find here. It's in reference on a MSP LSD and the 5th gear swap, but has some reference to what you ask

http://www.imazda.com/forums/showthread.php?t=2701
(requires to register and login, well worth it for this thread)

nolig2278 · Post by **nolig2278** » April 17th, 2007, 5:45 pm

great link, thanks

MazdaNoob123 · Post by **MazdaNoob123** » April 20th, 2007, 2:41 am

mxmaz wrote:I am willing to bet that the shorter geared mx3 tranny will make for a quicker car. This is the only forum i have ever been on where people think longer gearing is better.

With the right suspension the K8 tranny would be faster.
But look at it this way
you can only transfer just so much power to the track.