engine tuck ?
engine tuck ?
i was reading a car magazine and saw tips on how to do a wire tuck for your engine bays to clean them up, i have only seen one mx-3 with it done but just wondering if anyone has done this or has any pointers i was thinkin aobut giving it a shot but it would be only bits at a time.
it's really not practical unless your re-wiring the bay..
Alot of the wire leads are run only as long as they have tobe and not long enough to facilitate a good clean and invisible wire path...
if you wanna clean it up my suggestion is buy some quality heat-resistant wire loom and make it look as good as possible..
Alot of the wire leads are run only as long as they have tobe and not long enough to facilitate a good clean and invisible wire path...
if you wanna clean it up my suggestion is buy some quality heat-resistant wire loom and make it look as good as possible..