plant city florida?
-
- Senior Member
- Posts: 2165
- Joined: December 7th, 2002, 2:01 am
- Location: windsor, ontario
- Contact:
plant city florida?
Is there anyone in the plant city florida area? i am checking out an mx-3 there and considering buying it and driving mine down there and swapping my engine in there (and a new trans cause the one in my car is basically shot). was hoping someone in the area might be willing to help a little if they have tools I could borrow while down there since it would be hard to bring all of mine down there.
ProjectMx
My BP and AWD build thread
Cardomain
93 Mx-3 GS with bp and GTR AWD system
93 Escort GT daily driving
My BP and AWD build thread
Cardomain
93 Mx-3 GS with bp and GTR AWD system
93 Escort GT daily driving
- ruthless_mx3
- Regular Member
- Posts: 183
- Joined: October 3rd, 2003, 2:01 am
- Location: Tampa, FL
plant city is between tampa and orlando just outside of tampa like 15 mins.
I'm in north tampa if I can be of any help. pm me though cuz I'll probly never check this section of the forum again for a long time.
I'm in north tampa if I can be of any help. pm me though cuz I'll probly never check this section of the forum again for a long time.

93 MX3 GS SE KLZE -- RIP May 1, 2011
14.007 @ 98.46 1.991 60ft -- the only time she made it to the 1/4

92 MX3 GS aka Goldmember - I'm trying to keep the legend going and as always credit to Andy for starting the legend

sc61 currently @ 8 psi, wiseco 10:1 pistons, K1 rods, ported ze heads w/ kl31 cams
-
- Senior Member
- Posts: 2165
- Joined: December 7th, 2002, 2:01 am
- Location: windsor, ontario
- Contact:
found one in MI i might buy... waiting to hear back and have my brother look at it... thanks though guys
ProjectMx
My BP and AWD build thread
Cardomain
93 Mx-3 GS with bp and GTR AWD system
93 Escort GT daily driving
My BP and AWD build thread
Cardomain
93 Mx-3 GS with bp and GTR AWD system
93 Escort GT daily driving
-
- Junior Member
- Posts: 3
- Joined: August 30th, 2007, 8:54 am
- Location: Tampa, Florida
Orlando
I've done a BP swap on mine already so I'd be down to help. I wouldn't have too much to offer as far as tools though. I did mine w/ nothing more than a pair of jack stands and an engine hoist.
Let me know if I can help though.

Dan Sharpe
'92 owner
mx-west member
'92 owner
mx-west member