Shelby GT Racing Stripes

projectmx · Post by **projectmx** » October 18th, 2006, 2:33 pm

lookin good, and i have no idea of canada's laws sorry

Nd4SpdSe · Post by **Nd4SpdSe** » October 18th, 2006, 3:22 pm

The intake shouldn't, if not make it run cleaner (theoritically, more air should make it burn cleaner and leaner)

Where around Ontario are you from? Hope to see you at some meets, probably not this year since the cold weather is around the corner, but next year.

Oh, and don't forget to check out the Toronto Mx-3 section

Red Egg · Post by **Red Egg** » October 18th, 2006, 7:41 pm

Red Egg · Post by **Red Egg** » October 19th, 2006, 9:59 am

Hoodzy · Post by **Hoodzy** » October 23rd, 2006, 1:45 am

meh doesnt really work

Red Egg · Post by **Red Egg** » October 23rd, 2006, 3:42 pm

Tunes67 · Post by **Tunes67** » October 23rd, 2006, 4:15 pm

You should be doing this in the worklog section rather than in the Appearance forum. I like the stripes.. but I think if your going to go for the GT look.. go all the way and do a bottom stripe along the bottom of the door.. could have it say MX-3 KLZE or indicate whatever engine you have or MX-3 SC or MX-3 Turbo.. just some thoughts..

Tunes67

Red Egg · Post by **Red Egg** » October 24th, 2006, 11:03 pm

Juans_93_MX3 · Post by **Juans_93_MX3** » October 27th, 2006, 9:54 pm

Its still a -35hp car

I think it would look better with a Mazda Speed front bumper though and a BPT swap

Red Egg · Post by **Red Egg** » October 28th, 2006, 12:55 am

Red Egg · Post by **Red Egg** » November 13th, 2006, 2:29 pm

panheader · Post by **panheader** » November 13th, 2006, 8:06 pm

I like the stripes...thinkin they'd look good on my car