jb weld putty to fix spoiler mount?

ninjajim4 · Post by **ninjajim4** » May 17th, 2006, 3:51 pm

my hatch garnish has broken a mount, and i wanted to know if this:

http://www.gemplers.com/a/shop/product.asp?T1=134254

looked like a good bit to use for repair. thoughts?

lakersfan1 · Post by **lakersfan1** » May 17th, 2006, 4:01 pm

Most people with a broken garnish mount eventually just have to get a new mount. The only way I personally would even think of trying to fix it would be with some fiberglass cloth soaked in plastic epoxy. That's how I fix my plastic parts. But it depends on if there's a lip on the break to hold both pieces to the fiberglass cloth. Do you have a pic of the broken piece and the mounting point?

Nd4SpdSe · Post by **Nd4SpdSe** » May 17th, 2006, 8:42 pm

I used that stuff to fill holes in my cellphone holder so i could customise it, it cures really hard.

This was the original holder.

I used JB weld to fill those holes for strength. And modded it into this:

Works really well, that's my first experience with JB Weld