will this work - powerwindow switchs from a 92rs to a 92gs?

Grant888 · Post by **Grant888** » January 2nd, 2006, 7:25 pm

Title says it all, will the power window switchs from a 92rs work in my 92gs?

..sorry if this is a "complete yes" i'm new and dont knoew much about all of this.
thanks Grant

FlyVFR · Post by **FlyVFR** » January 2nd, 2006, 10:21 pm

The ETM shows only one diagram so I would say yes.

Grants · Post by **Grants** » January 3rd, 2006, 7:38 pm

Yes - same year so ok.

93_mx3_gs · Post by **93_mx3_gs** » January 5th, 2006, 1:34 am

Depends if the harness is running into the door, if not..it will be a pain in the butt. If you can find a junker with power options, try to get the door off and the harness out of the door that runs into the cab. I think it goes to the side of the fuse block/box. Maybe not i'm not sure. THis only needs to be done if you don't have the harness.

FlyVFR · Post by **FlyVFR** » January 6th, 2006, 11:08 pm

93_mx3_gs wrote:Depends if the harness is running into the door, if not..it will be a pain in the butt. If you can find a junker with power options, try to get the door off and the harness out of the door that runs into the cab. I think it goes to the side of the fuse block/box. Maybe not i'm not sure. THis only needs to be done if you don't have the harness.

I thought the question was about the switch

Besides all switch assemblies I have seen have a quick disconnect. Which can easily be separated from the wire harness after removing the screws that hold the assy. in the door panel.

Slade · Post by **Slade** » January 7th, 2006, 10:43 am

I have a switch for sale, but its from a newer than a 92 I think, it has the auto option on it.