CeNet wiring for Clarion

Flashpoint2 · Post by **Flashpoint2** » September 4th, 2005, 4:09 pm

I can't seem to get my changer running! I know the changer works, but apparently I do not have the power wire for the CeNet connected. I looked on the harness, and I can't find a wire that I havent used, so I'm rather confused. The actual CeNet cable is hooked up, but does not recognize the changer at all -- no power, no new options on the screen.. nothing. So does anyone have a wiring diagram for Clarion? its a DXZ945 or something like that (touch screen head unit). I've looked for the wiring diagrams online, but I cant seem to find any. Any help would be appreciated!!

Typhoonk · Post by **Typhoonk** » September 6th, 2005, 9:37 am

I looked into it for a bit. Clarions support page is down so that's not too helpful.

I'm guessing u have a DXZ955MC? the one u have to stroke the head unit to change tracks.

And this (DCZ625 ) seems to be the only changer that uses CeNet.

I say give em a shout at 800-GO-CLARION (462-5274) or
800-347-8667

I found both the manuals for your head unit and the changer DCZ625. All I could find is that u have to set the address switch depending on how many units u have attached to the source unit. If you only have one changer then set the switch on it address 1. The Deck's user manual wasn't too helpful for an 8mb file.
I have the changer manual so if you want it, pm me an e-mail address and I'll send it too you (changer manual is 540kb)