Exahust question

V6 Technical/Performance Discussions
Post Reply
Rhino236
Junior Member
Posts: 23
Joined: May 4th, 2004, 2:01 am
Location: Florida

Exahust question

Post by Rhino236 »

Im looking for a header for a 92 mx 3 Gs and a cat-back exhaust system.
1992 Gs
Image
User avatar
Talon_66
Regular Member
Posts: 1085
Joined: June 12th, 2001, 2:01 am
Location: Edmonton
Contact:

Re: Exahust question

Post by Talon_66 »

Pacesetter
93 GS, KLZE, KL31 ECU, Centerforce Stg 3 Clutch, 2.25" Exhaust w/Flowmaster muffler, OBX Headers, Pheno Spacers, Front & rear X-drilled/slotted Rotors, KVR pads, SS brake & clutch lines, Ractive Filter, H&R Springs, Tokico Blue Struts, 8mm Accel Wires, MSD 6A w/ Blaster 2 Coil, HVAC Indiglo Panel. *Sold*
06 Eclipse GT *Sold*
08 Evo X GSR *Current*
Rhino236
Junior Member
Posts: 23
Joined: May 4th, 2004, 2:01 am
Location: Florida

Re: Exahust question

Post by Rhino236 »

yeah ive seen pacesetter before, does it sound good?
1992 Gs
Image
TsiMiata
Regular Member
Posts: 1074
Joined: July 30th, 2003, 2:01 am
Location: Cape Cod, MA
Contact:

Re: Exahust question

Post by TsiMiata »

I have a pacesetter. It's just OK. The sound isn't great but not awful, the fit isn't great but not awful either. For $200 shipped you can't beat it. Overall though I wish I got something else. I think I'm going to have a custom built exhaust done next.
93 MX-3 GS- ZE, KL31 ECU, Fidanza Flywheel, CM Stage 2-R clutch, Hotshot Headers

99 Subaru Impreza RS, the new toy

91 Eagle Talon Tsi AWD *RIP*
DJ
Regular Member
Posts: 260
Joined: November 25th, 2003, 2:01 am
Location: Brockville, Ontario, Canada

Re: Exahust question

Post by DJ »

I am also looking for an exhaust system. I want something that sounds like stock or very close to stock. According to the V6 faq the mazdaspeed exhaust at corksport.com is suppose to add decent HP and sound stock but it is kinda pricey (600US). Anything cheaper that would give the same sound? Flowmaster or ractive muffler's with tip or do they end up sounding like some one is farting like most do?
Thanks!
Image
User avatar
johnnyb
Supporting Member
Posts: 1079
Joined: January 26th, 2003, 2:01 am
Location: Brampton, On, Canada

Re: Exahust question

Post by johnnyb »

if you go to any respectable exhaust place (not a chain like mr. muffler or thruway muffler) and tell them you'd like a performace muffler that is quiet then they will be able to accomodate that. It isnt a kit you buy but a custom setup. Here in this house we've had 3 exhaust systems done on cars one was very loud, the next was somewhat loud and the third sounded like stock until you reached higher RPMs but even then it wasnt much louder than stock. I'd suggest doing that.
Image
eldondemarco
Junior Member
Posts: 9
Joined: February 17th, 2004, 2:01 am
Location: El Paso Texas

Re: Exahust question

Post by eldondemarco »

I just recently bought a universal performance muffler from Megan racing. Specs for the muffler are 2 1/4 input with a 4 inch tip. It sounds beautiful! A nice deep toned sound, no farting at all. Gained me a decent amount of torque and HP and is not too loud. Just perfect with a custom cat back of 2 1/4 inch piping. Just a suggestion. I'm happy with mine.
Rhino236
Junior Member
Posts: 23
Joined: May 4th, 2004, 2:01 am
Location: Florida

Re: Exahust question

Post by Rhino236 »

ttt
1992 Gs
Image
Gro Harlem
Senior Member
Posts: 3391
Joined: November 30th, 2001, 2:01 am
Location: Stuttgart, Deutschland
Contact:

Re: Exahust question

Post by Gro Harlem »

pacesetters suck. Fitment is terrible, you'll end up spending another $200 in custom flanges and welding to get it to fit properly.

And on top of that, they are very rust-prone, and they sound raspy past 5000rpm...horrible sounding.

The only good part about them is they have been known to dyno the highest gains out of all the other designs out there, but IMHO its not worth losing the tuned sound of the K-series V6 just to gain an extra 2whp.

Get some hotshots or bosals.
Noble Green Metallic 93' GS Hybrid, 91' 1.8 323
DONATE TO MX-3.COM
User avatar
PATDIESEL
Senior Member
Posts: 4476
Joined: August 13th, 2001, 2:01 am
antispam: ~SPAM*SUX~
Location: Atlanta, GA.

Re: Exahust question

Post by PATDIESEL »

Mnemonic, from MOCA, had a Pacesetter and it rusted out in about two months. In Georgia that should never have happened. He noticed it starting in a few weeks and called Pacesetter, they told him tough luck. I have a flowmaster exhaust on my ZE (headers, cat, 2.5 pipe) It sounds great untill 4k rpm then gets the most raspy sound that I have ever heard. So I would stay away from those two brands. :rant2:
Image
ZE -strait neck,headers,2.5 exhaust,pheno spacers,lower cross member,GC coils,MS struts,Brembo slotted rotors,filled MS mounts,SS brake/clutch lines, CAI,to rear bat reloc,Hella headlamps,Hella DE fogs 180WHP
Post Reply

Return to “V6 Technical/Performance”