how to run cables from engine bay?
-
Sparky75
- Regular Member
- Posts: 108
- Joined: February 11th, 2002, 2:01 am
- Location: Northampton England
how to run cables from engine bay?
Im putting an alarm and a sub in my MX-3 V6,<BR>wheres the best location for the alarm and where can i run the wiring?? cheers.
My MX-3 (Presso Eunos) 93 spec Right hand drive.<BR>Mods..<BR>Sullivan racing Alluminium Race Pedals.<BR>17x7" MB Molini Alloys with 215/40/17 tyres.<BR>Glass headlight/one smashed 
<BR>PRM Intake Kit.<BR>Front Strut Brace.<BR>Erebuni Bodykit & GTR Rear Spoiler on the way.
<BR>PRM Intake Kit.<BR>Front Strut Brace.<BR>Erebuni Bodykit & GTR Rear Spoiler on the way.-
Sonicxtacy02
- Senior Member
- Posts: 2053
- Joined: January 1st, 2001, 2:01 am
- Location: Woodbridge, VA, USA
- Contact:
Re: how to run cables from engine bay?
most people put the brain to the alarm where the ecu is (down by your right leg, remove the panels there). As far as running the wires to the battery, there is a rubber circular grommet that sits on teh firewall. If you look down behind the dash on the drivers side you will see it up and towards the left. You can also see it in the engine bay. Just poke it through and run your wires through there. Be sure to wires along the firewall and not in front of the pedals etc.
Shaun Newman
SOLD 1994 Blaze Red GS/ SOLD 1994 Chaste White GS-R
SOLD 1994 Blaze Red GS/ SOLD 1994 Chaste White GS-R