MX-3.com

I've installed the fans from a V6 probe. The look a lot beefier, but i don't have any cfm numbers...

onlytrueromeo wrote:Does the Mazda 6 steering wheel have radio buttons and cruise on it? I've been looking for one of these styles of wheels for a reasonable price w/ the middle insert and they're alot harder to find than you think!

Yes it does The airbag module is pricey but just keep looking...

I've made a Mazda 6 steering wheel fit, so i guees a RX-8 would fit too. You have to make a small modification to the back. ( 5 min. with a grinder )

I've been driving 18" for nearly 5 years now. NEVER had a bent or cracked rim!!!

General opinion here is don't do it....

I'm on my second set of 18" now and it's great, even with a 35mm drop. So my opinion - DO IT

fowljesse wrote:Oh, my bad
I don't know anything about the harness.
Wiring mine in wasn't bad at all, and I seriously HATE doing stuff like that.

Okay.
I agree the wiring doesn't look like it's a big job, and it's probably the route i'm going to i'm just curious

You ned to go through the intiation of reading the MegaManual! It's like hazing for the brain. Even if you had everything setup for you to plug and play, you'd miss alot of important information that will help you tune your MS, if you don't read it.

That's not the problem. I'm totaly aware of the ...

Okay, but how does it work/plug in ?

Hi, i bought a standard megasquirt unit from the last probetalk bulk buy. I haven't recieved it yet, but i'm planning the installation. I've heard that there is a mx-3.com member that makes a PnP harnes for the mx-3. Does this work with this unit, and how is it PnP ? Is it possible to quickly shift ...

http://www.bilgalleri.dk/uploads_large_wm/1497348.jpg?877071

This is the connector i'm confused about. My A/C wiring harness have 4 sockets for relays(K8), but only a 4 pin connector(B6) according to this diagram. :shock: I have 2 wiring harness' now and they are both this way. (On has a ...

I've been looking at some pictures in the engine bay thread, and it looks like the 4 pin connector is more common. Does anyone have a 6 pin connector (White connector, near the firewall, next to the A/C relais) with the wiring connected, that could check how many wires are connected and to which pins.

Hi, i'm in progress of installing an A/C system in my '94 mx-3 GS. I'm having some problems with the wiring. I have a connector i can't find the right place for. I have a white 6 pin connector on the car near the A/C relais which i would suspect would hook up to the A/C wiring, but no it's only 3/4 ...

Hi, the relais are located on the right side of the enginebay behind the strut tower. Just follow the wiring from that point.

Hi,

I'm mounting an A/C system in my car (94 mx-3 v6) and i'm in need of the 2 seals between the heater and the cooler core and between the blower and the cooler core.

I also need all of the A/C wiring in the engine bay + the relays and brackets for these.

Hi,

I'm in need of an ecu for a '94 mx-3 with a kl-de engine. Ecu number should be either kl48 or kl55 (Probe and Mx-6 number) Don't know the '94 626 number. kl50 or kl57 should be the CA versions and i would prefer the kl48/kl55.

Anyone willing to sell ?