MX-3.com

piggyback i just installed an ultimate on a turbo miata , i usually dont touch piggybacks but honesty one of the best options i've seen out there but if your goin big jsut save a few hundred more and get a microtech

what kindda help u want.......rip that sob out and rebuild, if possible if crankshaft got phukd and cilinder walls got phukd then your pretty much PH\/KD...

everybody loves ditchin their egr's, now the funny thing is theirs no reason why, it actually helps alot, when open it richens yours afr those gases r very flamable so they make u run richer helps full economy alot, plus if u use your mind and r bored enough u can use it 2 your advantage in certain ...

an oil pressure gauge is different from an oil temp gauge all cars already have an oil pressure switch u can just use that fitting 2 install the new sensor, and the water temp gauge also has a fitting 2 install the sensor, but since our engines dont have an oil temp gauge i waswondering if anybody ...

wondering if anybodys installed an oil temp gauge on a v6 if so where did u put the temp sensor

if your talkin about an automatic tranny then this might help u and alot of other people who dont know this little known fact.....all automatic tranny fluid has cleaning agents added to it to clean help clean your tranny, problem is when u dont change it for long periods of time and the disks inside ...

mad bad i didnt mean stock rods i meant forged rods thinkin of throwin a few pounds of boost at my k8 see how it reacts

anybody know if anybody makes piston rods for k8 engines or if kl series rods fit

ive been workin on cars since i was a kid ive done hundreds of cars its my job and i personally have never warped a rotor using an impact wrench i dont even see how its possible i do know of people like guys at pepboys i think they have 2 use a torque wrench but i dont and prolly never will ive ...

the correct way to install control arm bushings...........after you press the bushings and install the control arm dont tighten the bolt, u have 2 have the car on the ground the way it would b normally then tighten the bolts. in reality this is pretty much impossible 2 do so what i usually do is put ...

i've posted this on here b4 i personally think the k8 hasent been pushed 2 the limits im sure it has over 300hp in it u just have 2 b smart about creating it, now as anyone whos built a fast engine theres no replacement 4 displacement however, i live in an import lovers heaven we just love em if u ...

does anybody have specs on the k8 versus kl engine internals, by that i mean stroke piston sizes, just wondering if its posible 2 stroke a k8 engine, everybody seems 2 have a hard on for the klze but nobody seems 2 have tapped into the full potential of the k8, we make little piece of crap pocket ...

its supposed 2 b real hard

if your engine was runin messed up the night b4 then there isnt anything wrong with your starter, starters r just that they start the engine, if your starter wont catch the flywheel then take the starter out and check the bendix or turn the engine by hand and check the flywheels teeth, if ...

im in just wanna know how much its gonna cost and how much will shipping b here