MX-3.com

Thanks for the info. After some additional measuring, cutting and fitting I ended up with the cover for my son's car. Total cost for some fabric, cord and salvage plywood was about $6.00. See the links below for some assembly pictures.

http://img.photobucket.com/albums/v238/MarkBrad/hatchcover/MVC ...

I am going to fabricate a cargo cover but need some help with the dimensions. What is the overall length at each of these dimension points, at the edge, at the angle and at the center indentation? How far from the edge is each dimension change? See my crude sketch. What is the pivot pin diameter ...

Thank you. I will give it a try in the next several days.
Ever try to change out the fuel filter in the engine compartment??

I have searched the online manual on how to adjust the idle, but the change I made did not take. Can someone post the correct sequence for making the change.
1. Engine on /off?
2. Run the jumper wire?
3. Adjust the idle speed?
4. Pull the jumper?
5. Stop engine?

I should have said that all I found was a Pacesetter for a 1.6 SOHC. We a have a 1992 1.6 DOHC. Any difference in the exhaust systems?

Can you point me to a source? All I see is Pacesetter for SOHC 1.6L.

My son wants to add a "hot" muffler. Does anyone have any experience adding just a (Ebay?) muffler for looks and sound? The car is a 1994 1.6.
The standard setup looks the final piece is a flanged exhaust pipe and muffler in one assembly. Do I cutoff the old muffler and add a 2 1/4" inlet ...

Will a GS spoiler bolt right on to an RS body?

Two guys at the parts sotre swear by SeaFoam. They told me to let the engine suck up about a third can through a vacuum line until the it stalled, let it sit for ten minutes and start it up again like a flooded engine. I am going to give it a try in the next week or so.

I drilled through the two dimples in the bumper face and saw a metal plate. The 6MM x 1.0 screw threaded in a couple pf turns then stopped. I never could determine if it was the correct thread or not. Unfortunately the plate ended up falling into the bumper. Bigger holes squared off and plastic ...

Well, we ended up replacing just the two lower motor mounts. The passenger side upper looked good. The "extra" one along with the two used ones are available if you need one. The lower rear mount was gone but I still have a rough idle in drive. I did find one cracked vacuum line and replaced that ...

He did go to a with the car info to a local parts store and came back with
http://www.rockauto.com/ref/SMP/SMPDetail2.html?JR160.jpg
He said the part was stamped T239 like the picture.
My VIN is in the lower than serial number category and that part should work.
But he says the rotor is a loose fit ...

My brother-in-law has been doing some work on the car., 94 1.6L auto. He says the donut hole on the motor mount I bought is off 1/2". The old one is in good shape. Could the original have "sagged" that much or is it the wrong one? The other two mounts have been replaced, the rear one was broken. Do ...

My car (1994 RS) has a two? level console, but is missing the smooth lid. Is the stock lid the same or is this piece unique? Does anyone have one? Thanks.

The car we bought came with the optional alloy 14" wheels and four mismatched tires, but all the same size.
I want to upgrade to just 15" wheels and new all season tires. Being able to carry a spare tire that works is keeping me at 15" as well.
Any suggestions for nice looking wheels at a reasonable ...