Page 1 of 1
K8 5speed G5M-R rebuild kit
Posted: January 7th, 2014, 11:22 am
by Thefez
hey guys I was wondering if you knew of any place that sells rebuild kits for the G5M-R trans i ordered a mfactory and want to re-syncro my trans along with new bearings a seals and what not bascily looking for a "Master Rebuild kit" thanks -fez
Re: K8 5speed G5M-R rebuild kit
Posted: January 7th, 2014, 9:10 pm
by crazycanadian
I don't have any part numbers or sources for you to buy online.. I buy my parts threw local transmission supply companies... But here are a couple threads I have done with lots of info on rebuilding/tearing down a G-series transmission... You'll need some special tools to measure end clearance.. You'll also need to order some shims from mazda in order to set the bearing pre-loads properly.. No one can tell you what shims you will need until start building the transmission and measure the end clearances.. I don't have any part numbers since all the shims I have, I acquired from tearing down and parting out a few transmissions...
This is a B6T, G-series transmission, but the KL's and BP's all come apart the same way...
http://www.clubprotege.com/forum/showth ... highlight=
My cars build thread.. Pages 12 and 13 have more info...
http://www.clubprotege.com/forum/showth ... %29/page13
Re: K8 5speed G5M-R rebuild kit
Posted: January 9th, 2014, 6:33 pm
by Thefez
care to sell me a mess of shims? and ya i know i need measure equipment im a mechanic.. my trans place only sells auto trans parts go figer lol...
Re: K8 5speed G5M-R rebuild kit
Posted: January 10th, 2014, 10:03 am
by crazycanadian
Sorry bud... I only have a small mess of them... When you do get into it, they aren't that expensive from mazda..