MX-3.com

I got a KLZE in my 92 mx-3 when i jumped the connector to get the enging code it was flagging this is what i got. Im not sure what its telling me...

I got 9
and maybe 14??

Thanks

http://www.youtube.com/watch?v=fLk9mrdDCG4

9 + 24

OBD-1

02- crankshaft position (ckp) sensor or circuit
03- camshaft position (cmp) sensor or circuit
04- camshaft/crankshaft position sensor or circuit
05- knock sensor
08- Mass Airflow (maf) sensor or circuit
09- coolant temperature sensor or circuit
10- Intake air temperature sensor (IAT)
11- Intake air temperature (IAT) sensor or circuit
12- Throttle Position sensor (TPS) or circuit
14- Barometric Pressure Sensor
15- Oxygen sensor or circuit
16- EGR valve position sensor or circuit
17- Oxygen sensor (check the fuel and ignition system performance)
23- Rear 02 sensor inactivation error
24- Rear 02 sensor inversion error
25- Fuel Pressure Regulator Control Solenoid or circuit
26- Solenoid valve(purge control) or circuit
28- EGR vaccum solenoid
29- EGR solenoid vent or circuit
34- Idle Air Control(IAC) valve or circuit
41- VRIS #1 solenoid
46- VRIS #2 solenoid
67- Cooling fan relay or circuit
69- ECTF sensor

111- System pass
112,113- Intake Air Temperature(IAT) sensor or circuit
116,117,118- Engine Coolant Temperature(ECT) sensor or circuit
121,122,123- Throttle Position Sensor(TPS) or circuit
157,158,159- Mass Air Flow(MAF) sensor or circuit
172,173,179,181- Heated oxygen sensor(H02S) or circuit
211,212,213- Ignition system
214,244- Camshaft position(CMP) sensor or circuit
327,332,337- EGR function sensor or circuit
411,412- Idle Air Control(IAC) valve or circuit
452- Vehicle Speed Sensor(VSS) or circuit
511,512,513- PCM
519,521- Power Steering Pressure(PSP) switch or circuit
522- Transmission range sensor or circuit
536- Brake On/Off (BOO) switch or circuit
538- Dynamic response test
539- a/c sensor or circuit
554- Pressure regulator solenoid valve or circuit
559- a/c relay or circuit
563- cooling fan relay(high speed) or circuit
564- cooling fan relay(low speed) or circuit
565- Purge control solenoid valve or circuit
571- EGR solenoid valve(vent) or circuit
572- EGR solenoid valve(vaccum) or circuit
998- PCM

the code 9 is from the 2nd coolant sensor that probably didnt come with your klze. if you still have your k8 and look near the coolant fill cap there is a sensor your klze is missing. you need to drill/tap a hole and put that sensor in to remove the code.

you guys are amazing!!!!

so would that cause the rpm to jump up and down?

it can, the ecu uses the sensor to adjust the fuel mixture.

most bouncing idle is from vacuum leaks thow.

That sensor causes the idle to bounce around a lot as well as just stop and start to bounce, my sensor went bad last summer.

what temp sensor works with the klze?