MX-3.com

Alright so here is my baby, needs alot of work I know but any opinions or inputs are very much welcomed.

took off the front bumper cause i couldn't stand looking at it


some photos of the rear



Took the back seat out no one gonna be riding wit














pictures of the rear strut tower i put some stuff on it to stop the rusting and s--- also just got some Recaro seats from a EVO8 that I just put in but don't have pictures of yet. Gonna get a halo headlights wit HIDs. I got a bunch of stuff in my house that i haven't put on yet because i plan on doing a KLZE swap but im trying to find some steel rods instead of aluminum if anyone has suggetions because im getting 11.5.1 pistons to increase my hp : ) but i dont know what to over bore it to etc but when i get the camera back from wifey ill take some photos of the stuff i already bought for the klze

see a bunch of views but no responses *cries* but naw here are a few things I've picked up for the KLZE i just got. photos below

seat with cover


without it ugh...


new recaros out of a evo8


out with the old


in with the new


all the stuff to go into my car, rotors, brake pads, oil filter, fuel filter, ball joints, water pump, alternator, power steering pump, outter tie rod, bosch fusion spark plugs, and i think thats it for now.


royal purple oil (the royal purple filter is in the other photo)


Rest are just pictures of the motor









And my friend having a lil fun lol

any one have suggestions on interior panel replacements?

Junk yards and the FS section here are your best bets for interior stuff. My last MX-3 had been painted silver inside...poorly and I managed to replace everything out of my local yard for about $60. It took a little while though.

Good luck with your build.

I waited a year to get some minty interier pieces then sold the car cheap Point is be paitent. I want to see if a friend can do the cloth section on the door in carbon cloth. Thought that might be cool. Keep up the good work.

wytbishop wrote:Junk yards and the FS section here are your best bets for interior stuff. My last MX-3 had been painted silver inside...poorly and I managed to replace everything out of my local yard for about $60. It took a little while though.

Good luck with your build.

See but the main issue is most of the junk yards don't have a Mx-3, i was lucky enough to find a gauge cluster for it. Also I took apart my KLZE but I didn't have my camera while we were doing it but ill post pictures of it afterwards. Bringing it to get hot tanked and all that good stuff, overbored etc. Plus the guy I bought it off of said it had a bent valve and that it didn't hit the piston, but sure enough once we opened it, it did, rods are good but pistons are done for (good thing im getting new ones). Also just got a fidanza short shifter and going to be getting new bushings for it from clubprotege. I'll show pictures of the messed up pistons when I get back over to the garage its in.

Alright after a long hiatus from my worklog here a few pictures of what it looks like now.









If anyone has any suggestions on how to take the oxygen/fade out of the CB hood please let me know and on how to fix up the alignment on the front bumper. Probably will just end up bringing it to a shop though.