Page 1 of 1
HID adjustment Spyder
Posted: March 2nd, 2009, 11:39 am
by nolig2278
Can the bean/patter be adjusted on these new HID lights that come with the Spyder case?
Basically the beam is showing a couple straight lines near the top of the beam.
Can it turn?
Re: HID adjustment Spyder
Posted: March 2nd, 2009, 12:24 pm
by solo_ryder
WTF is bean/patter?
Is that a form of bread?
Re: HID adjustment Spyder
Posted: March 2nd, 2009, 12:29 pm
by Daninski
Spyders throwing in pitas with every light purchase. Bean Patter pitas, its all the rage in California. lol
Re: HID adjustment Spyder
Posted: March 2nd, 2009, 12:31 pm
by RS_OBD'oh_2
LOL
I think I had some bean/patter lastnight.. not for me.
I'm guessing beam-pattern (non loaf).. and no idea
Re: HID adjustment Spyder
Posted: March 2nd, 2009, 12:44 pm
by rekognize
Re: HID adjustment Spyder
Posted: March 2nd, 2009, 12:49 pm
by fowljesse
If I understand the question correctly.. Mine were really close out of the box. I adjusted the passenger's side to perfectly match the driver's side. It took 1 minute, and the cutoff is great. The left side is lower, for oncoming traffic, and rearview mirrors..
Re: HID adjustment Spyder
Posted: March 2nd, 2009, 5:36 pm
by nolig2278
sorry i meant BEAM/Pattern
so how do they adjust?
Do i need to pull the light housing out of the car?
Re: HID adjustment Spyder
Posted: March 2nd, 2009, 9:54 pm
by fowljesse
There are a couple of hex bolts. I think they were 10mm. You turn them one way or the other while they're installed in the car.
