MX-3.com

i thought i would share some photos and info about my car so here it is

Fresh rebuilt BP-T with less than 15k miles on it.
miata tubular header
garret t3 turbo
38mm external wastegate dumped to atmosphere
2.5 inch catless turboback
apex-i n1 exhaust
hks bov
fmic/hardpipes
ported gtx intake manifold
bp55 ecu
apexi safc II
rx7 460cc injectors
msd 6al ignition box
msd blaster 3 coil
short shifter
poly bushings on sway bar, shifter, motor mounts
ground control coilovers
tokico s/r struts
v6 rear tie bar
gtx strut bar
rear strut bar
arp extended wheels studs
walbro 255 fuel pump

i just got the car back in november only problems with it are drivers side wheel bearing, passengers side inner tie rod

the battery light is on but it starts right up every time not sure what is causing it

the check engine light is also on for some reason no clue why unless its a problem when you do a bp swap because your not supposed to get check engine lights with any gtx ecu

Nice looking car! Welcome to the club bro

Yeah, Nice! It looka familiar...The shocker... Was there a picture up before?

jdm tight yo.

flojesse i got it from another member on clubprotege maybe you seen the pic's there


projectzemx3 lol no response

Hey Smoke, glad to see you made it over from CP, Welcome!

Hey! I think you were the guy that I picked up the CF Protege hood for Colin's 323?!

well it was an escort hood but yes that's me


hows it going

hotsiit wrote:Hey Smoke, glad to see you made it over from CP, Welcome!

so hows that etd racing manifold treating you

smoke187 wrote:well it was an escort hood but yes that's me


hows it going

Same diff, well no not really, but I don't remember, wasn't my hood, lol! Yay for smuggling a hood across the border! Actually, once I noticed your profile said Buffalo, I recognized you from the house and the garage. Guess you stuck with another Mazda, eh? And kept with the BP's....

If you don't know, Colin had to retire his 323 because of bad rust issues. I don't quite remember where the hood went off to.

I don't think we've met through anywhere else, but as you can see, I've been here and had my Mx for quite a while. Not bad, my ZE is blown, gathering parts for a major rebuilt that I'm hoping to start shortly into the new year.

Hopefully we'll see you at some meets in Niagara Falls, even the cruise night in Lundy's Lane had alot of US cars.

smoke187 wrote:so hows that etd racing manifold treating you

It is looking awesome sitting in a box in my garage ...Things have not gone as planned, and my overhaul/project has pretty much stalled...for the time being...

Hey yea I got ure hood! ahahah
It went to good use see! untill the frame rotted!


It's ok I got my new baby now!

yea i remember your car how come your not over at club protege anymore?

lol wow i love this thing. how much boost are you putting through it? the list of upgrades sounds like your ready to start putting down some serious HP. next stop GS rear disc?