MX-3.com

Ok I'm only posting this because I was searching on here and didn't find all the correct info. So this is the right info for other people that switch from auto to manual. This is mx3 info not probe or mx6. If you don't know what sensor is the reverse you can use a ohm meter to test it. Just hook it up and put it in reverse and there should be continuity. Next you need to know what wires are for the lights. There are two plugs you need. One is white with 3 wires and the other is yellow and has 12 wires. The white harness has the red/green wire and the yellow has the black/yellow. Lights work.
Now for the nuetral switch. All I did was I took the other two wires on the white harness and ran seperate wires through the firewall and to the switch on the clutch pedal assembly. Now you can't kill yourself or the starter.