MX-3.com

Well i finaly got my Reverse Glow Gauges in the mail put them in yesterday took awhile but i got them in. Then i relized the RPM needle was sticking *Damn*...
So iv been trying to think of ways to keep the gauge down so the needle wont stick i read on here tape but i tried that last night and it didin't really work that well. So if any other ideas come to mind i really welcome them.

Btw, Snapped the Needle so i gotta go buy a new gauge cluster from the junk yard

Thanks.

There are two things that I tried and both worked.

1. Put super glue on the back of the gauge face so its sticks flat

2. The BACK of the needle sticks (back of the stubby part that sticks out) take some sanpaper and move it back and forth under the stubby part of the needle and wear it down abit, it will eventually come free after a few minutes of sanding

Good luck!