Page 1 of 1
Harness's...where to bolt to??
Posted: October 29th, 2007, 10:33 pm
by import_fan7
i got racing seats and harness's i will bolt one or 2 of the strapes to stock mounting points but where to bolt the others ..just want to know other strong points in the car to bolt too?? without having to use thick steal plating welded undernieth the floor?
Posted: October 30th, 2007, 8:17 am
by lowridah313
If the belt is long enough, bolt it to the rear seatbelt mounts.
Posted: October 31st, 2007, 12:34 pm
by Yoda
Unless the seat in question it is approved by a recognised racing association not advisable to attach the tail straps of a harness belt so that they are low than 2" below your shoulder line or you will need to install a belt bar at shoulder level behind your seats for the belts to go over to prevent the shoulder harness from compressing your spine in the even of a accident or sudden stop.
Posted: October 31st, 2007, 5:10 pm
by monty73741
serous vaughn what dont u know about......how good are u @ finished carpentry....I need some crown molding installed ...
jaos
n
Posted: October 31st, 2007, 11:30 pm
by MazdaManiacMx3
I have been doing finish carpentry since I was 12 , PM me if you have any questions my father has been in the trade for over 30 years ,
Make sure you get someone good or you will have a painters nightmare up there and there will be gaps with loads of caulking in them .
Kris -