Page 1 of 1

Need Combo switch Wiring Help

Posted: July 30th, 2007, 5:26 pm
by Babymx3
Can someone help me decipher the wiring to my combination switch?

I looked at the online manual and some of it isnt clearly scanned...
And the wires seem to be different colors...
since Im working with a 92 MX3 RS rather than a 95.

I have a new combo switch with the new connectors...but I have to take the old wires and put them in the new connectors.
It would have been easier if I still had the stock connector.

So this is what I have as far as wires...Im just not sure of what they control.

These are the wires that are right at the combo switch.

****TURN SIGNAL/LIGHT CONTROL*****
Grn-Red []
Red-Wht []
Blk-Grn []
Grn-Yel []
Red-Blk []
Red []
Wht []
Blk-Red []
Grn []
Blk []
Grn-Red []

*****WIPER CONTROLS*****
Light Blu-Red []
Light Blu-Org []
Light Blu-Wht []
Light Blu []
Light Blu-Wht []
Light Blu-Yel []
Grn-wht []
Light Blu-Red []
Blk-Wht []

Posted: July 30th, 2007, 7:54 pm
by shameem
Download this before the link becomes unusable....

http://www.mediafire.com/?4dmaxt4vhmc

Posted: July 30th, 2007, 8:23 pm
by Babymx3
shameem wrote:Download this before the link becomes unusable....

http://www.mediafire.com/?4dmaxt4vhmc
Hey, THANKS :lol:

By any chance you have the part that tells you the pin out connections?
Just wondering I just browsed over what you gave me...
It is in depth...but just couldnt find the part that tells the pinout connectors.
I know know what wire is what...but dont know where to put them.

Thanks for your help.

Posted: July 31st, 2007, 6:44 pm
by shameem
I havent seen connector pinouts for 93 anywhere - you can try the online manual page Z-066 and go from there.

Odds are - the wire colors will be the same before and after the connector - so if you know what wire does what - you can pretty much "know" the pinout....

Posted: August 1st, 2007, 9:48 pm
by Babymx3
shameem wrote:I havent seen connector pinouts for 93 anywhere - you can try the online manual page Z-066 and go from there.

Odds are - the wire colors will be the same before and after the connector - so if you know what wire does what - you can pretty much "know" the pinout....
I will check that out.
the reason I was asking is a lot of the manual isnt scanned clearly...
I cant tell if someing is a O or a B. :oops:

Ill try and tackle this problem by this weekend...

Or if someone out there has a nice clean scanned copy of pages

Z-062
Z-063
Z-066