[WTB]Shifter Boot (94+)
Posted: July 29th, 2007, 7:24 pm
Looking for a used shifter boot from a 94+ . Doesn't have to be in great shaped as I will be using it for a pattern to make a new one.
MX-3.com
The Worlds First and Largest Mazda MX-3 Forums
https://www.mx-3.com/phpbb3/
[WTB]Shifter Boot (94+)
Page 1 of 1
Posted: August 7th, 2007, 7:11 pm
Anyone???
Posted: August 12th, 2007, 10:18 am
Posted: August 23rd, 2007, 7:35 am
bump
Posted: August 23rd, 2007, 11:04 am
Do you want the trim peice around the shift boot? PM me. i could probaly get you it.
Posted: August 23rd, 2007, 7:42 pm
No I want the actual shift boot as I'm making a copy of it.
Im on it
Posted: August 23rd, 2007, 8:37 pm
I'll use my original shift boot and make a printable
template so everyone can make their own
Gimme 48 hours.
If you really want the original one come pick it up
after I measure it out
template so everyone can make their own
Gimme 48 hours.
If you really want the original one come pick it up
after I measure it out
Posted: August 24th, 2007, 12:37 pm
Ok hope this works. Its half of the boot, so fold over some material
and then you'll have both sides. The picture scanned isnt quite as
big as the original (my leet scan skills arent as good as they used to be)
so extend it some on 8.5 x 11 inch paper by the indicated measurements.
Oh the plus or minus 0.2 cm is if you like it stiff or more relaxed
personally id add the 0.2 cm or even a lil more
Stitch along the right hand seam, inside out then flip it right side
about 0.25 cm inward or to taste
and then you'll have both sides. The picture scanned isnt quite as
big as the original (my leet scan skills arent as good as they used to be)
so extend it some on 8.5 x 11 inch paper by the indicated measurements.
Oh the plus or minus 0.2 cm is if you like it stiff or more relaxed
personally id add the 0.2 cm or even a lil more
Stitch along the right hand seam, inside out then flip it right side
about 0.25 cm inward or to taste