Page 1 of 1
Real Header from OBX!???
Posted: July 19th, 2007, 5:16 pm
by seboroth
Hey guys just saw this on ebay and didn't know if anyone else knew of this. It might be worth checking out.
http://cgi.ebay.com/ebaymotors/OBX-SS-E ... 4176QQrdZ1
Posted: July 19th, 2007, 6:45 pm
by atlantamx3
That is nice and is a good price too.
My question is-- which 1.6 will it fit? The SOHC or the DOHC?
They ARE different.
Not that I have a 1.6L anymore... but it is an important question that needs answering.
Posted: July 20th, 2007, 6:12 am
by SuperK
I'm pretty positive it's the DOHC, it looks almost exactly like my genie header sitting in my bedroom.
I can check real quickly my exhaust gasket and tell you if it's the same mount or not. That'd be the most definite way. I doubt the shipper can tell you which one it fits on.
Posted: July 20th, 2007, 2:42 pm
by Limegreen mx-3
the bolt patterns don't match for the 1.6 sohc.
Posted: July 20th, 2007, 3:24 pm
by Bumpysbro
it has 3 openings on it and my stock manifold has 2. whats the other one for? looks nice too but i hear some obx headers mess up or dont fit well. anyone else use these before?
Posted: July 23rd, 2007, 12:21 am
by Cy
In the Picture...It's not even remotely close to any b-series mazda motor boltpattern...Far as i know the Sohc and Dohc motors have different bolt-patterns...
either the picture is wrong or, more likely, the seller is a douchebag...
Posted: July 23rd, 2007, 10:28 am
by SuperK
Cy is right; I'm looking at my genie headers and my brand new exhaust gasket that I just bought...
the bolt pattern is very different.
B6 DOHC bolt pattern looks like this:
: . ' ' . :
whereas this one is simply:
: : :
Send all ASCII art compliments to my PM box please.
Posted: July 25th, 2007, 6:15 pm
by seboroth
hmm, well that figures. Guess I'll just stick with my gutted front cat till I get a bpt swap, or even better the rx-7 motor swap. Don't know if that one is true or not either, but found it here a lil while ago.