probe 2.5 air intake
Posted: March 25th, 2007, 11:00 pm
Will a probe 2.5 air intake work on my 1.8 V6?
MX-3.com
The Worlds First and Largest Mazda MX-3 Forums
https://www.mx-3.com/phpbb3/
probe 2.5 air intake
Page 1 of 1
Posted: March 25th, 2007, 11:33 pm
Yes it will, you need to CHOP the elboy.. and turn it 180 degrees, use a rubber coupler and walla.. fits right in like a glove (in the fender cavity) Cheaper than an integra intake.
Posted: March 26th, 2007, 12:17 am
ok thanks what one should i order?
eBay Motors: 93 94 95 96 97 Mazda MX6 626 Ford Probe V6 Air intake 1 (item 230106672325 end time Mar-25-07 23:35:3
eBay Motors: 93-97 Mazda MX-6 626 Probe GT V6 Air Intake 94 95 96 LS (item 180099129958 end time Mar-26-07 12:27:2
eBay Motors: 93 94 95 96 97 Mazda MX6 626 Ford Probe V6 Air intake 1 (item 230106672325 end time Mar-25-07 23:35:3
eBay Motors: 93-97 Mazda MX-6 626 Probe GT V6 Air Intake 94 95 96 LS (item 180099129958 end time Mar-26-07 12:27:2
Posted: March 27th, 2007, 7:01 am
Been looking into doing my K8 as well. Are you going to do a cold air intake?
Posted: March 27th, 2007, 4:20 pm
im not sure i might just put the short one piece ram air on it
Posted: March 27th, 2007, 9:13 pm
Get the one that goes all the way down to the transmission (ON THE PROBE GT) then ill show you where to cut, its quite easy 
It fits exactly like the integra intake but cheaper. it sits UNDER the water resevoir (i relocated mine) on that fender well gap thing.
It fits exactly like the integra intake but cheaper. it sits UNDER the water resevoir (i relocated mine) on that fender well gap thing.