Page 1 of 1
engine tuck ?
Posted: March 22nd, 2007, 11:47 pm
by 96mx-3
i was reading a car magazine and saw tips on how to do a wire tuck for your engine bays to clean them up, i have only seen one mx-3 with it done but just wondering if anyone has done this or has any pointers i was thinkin aobut giving it a shot but it would be only bits at a time.
Posted: March 23rd, 2007, 12:07 am
by Cy
it's really not practical unless your re-wiring the bay..
Alot of the wire leads are run only as long as they have tobe and not long enough to facilitate a good clean and invisible wire path...
if you wanna clean it up my suggestion is buy some quality heat-resistant wire loom and make it look as good as possible..