MX-3.com

okay i have two choices for a MS front i can get the Erebuni kit or the corksport one. which is eaiser to install and which is greater quality. also if you could tell me the general going abouts of intstalling at least the front it would be great thanks.

um yeah also i need this info kinda quick cuz i have one guy waiting on me if i dont decide i want it soon hell just sell it to some one else.. thanks again

Nick

IMO they are the same...

The Erebuni comes with a grill, the CS MS is plain.

I have them both, had more flaws in my CS one than my Erebuni.
You have to drill holes in both I think.

I've seen and installes a CS one. It had already been installed, prepped and painted by the body shop, but was taken off to aviod damage. It is a very nice fit though. They should both be the same. The question is where does CS get theirs. I don't think they acutally make them. As for which would be better, the answer is how many bumpers has the mold made for each company. The more a mold is used the worse it gets and the worse quality bumper finish. The worse the finish the more you will spend with the body shop to fill pin holes and sand out any waves.

thanks alot did yours fit right tight against the hood i noticed a few kinda sag in the middle where the grill meets the hood

If I'm not mistaken, the Corksport MS style bumper IS an Erebuni. Mine needed some work, but it fits almost 100%. When installed properly, there shouldn't be any gaps.

Mine fits well around the fenders and hood. The sagging part, that I've noticed is underneath the headlights. It's not so tight around this area than the factory bumper.