Page 1 of 1
What does this connector on the Engine Control?
Posted: September 5th, 2006, 1:05 am
by Blazianenigma
Hey,
Just replaced the Wires, Ditsy, plugs, well...a whole lotta other stuff but ran across this connector that was rotted or corroded away.
What "did" this sensor go to?
1993 4Cyc
Posted: September 23rd, 2006, 4:01 pm
by Bumpysbro
http://img.photobucket.com/albums/v381/ ... mx3pic.jpg
from the picture you provided it looks like your pointing to the oxygen sensor. is this right?
Posted: September 24th, 2006, 3:48 pm
by PATDIESEL
I think it is the water temp sensor on a B series block.
Posted: September 24th, 2006, 5:40 pm
by atlantamx3
PATDIESEL wrote:I think it is the water temp sensor on a B series block.
Correct. Well, its one of them anyway. There should be two... the other one is right behiond it.
It is on the thermostat housing.
Posted: September 24th, 2006, 7:12 pm
by Bumpysbro
ahh mines a 95 thats prob why i dont got it, nice catch guys
Posted: October 9th, 2006, 7:57 pm
by Blazianenigma
Thanks.
I tried finding theis at the Autozone...Advance and they didnt have the right one. What they had in the system as a direct replacement wasnt even the right one....it didnt even fit.
I eventually had to match the connector on the end from another car.
The guy there just started pulling random ones off the shelf to find one that looked the same height and had the same dual prong ending.
So far..it works fine.
Posted: November 14th, 2006, 11:40 am
by Fyujin
Its the fan switch. I know because I broke one already
