Page 1 of 1

Brembo Install - Pics!!!

Posted: July 23rd, 2006, 10:23 pm
by Bling Bling
Just thought I would throw out a few pictures of my new rotors. I a fellow club member ( Rece ) gave me a hand with them as this was my first attempt....again thanks dude :) The rotor replacement actually isn't too bad as long as the calipers are still in good working order. And when the rust stops progress, a little WD40 and a hammer become quite handy. Overall, not a big job. Here are some before and after pictures.....

Image
Image
Image
Image
Image
Image

Posted: July 23rd, 2006, 11:27 pm
by PATDIESEL
OMG, our brakes look so dinky in a large wheel. :cry:
Looks good though.
<I cannot say anything, I use the same rotors in a 17" wheel>

Posted: July 25th, 2006, 2:16 am
by mitmaks
17's wont last here long

Posted: July 25th, 2006, 8:16 am
by Bling Bling
:? Not sure what you mean

Posted: July 25th, 2006, 10:51 pm
by PATDIESEL
I guess he mans that the roads stink and they bend??

Posted: July 30th, 2006, 9:30 pm
by jschrauwen
Nice work Stacy!! :2thumbsup: Are they annondized as well. If not, it may have been very advantageous to paint the non-contact portions of the rotors to prevent rust.
So far mine don't show any signs of rust or degredation.


Image

Image

Posted: July 30th, 2006, 10:25 pm
by Bling Bling
I beleive they are annodized. Haven't seen any rusting as of yet. Hopefully never!! But then, I haven't really been out when its been wet yet. :lol:

Posted: July 31st, 2006, 12:36 pm
by mymx.3
I got new rotors too!!! :froggie_red: :mrgreen:

My calipers need to be painted yet .. some day :(


DEB :wink:

Posted: August 1st, 2006, 1:54 pm
by Bolverk
Bling Bling wrote:I beleive they are annodized. Haven't seen any rusting as of yet. Hopefully never!! But then, I haven't really been out when its been wet yet. :lol:
I have Brembo cross drilled too and they will rust once the brakes wear off the coating, but its only where the pad connects with the rotor.