Page 1 of 1
will this work - powerwindow switchs from a 92rs to a 92gs?
Posted: January 2nd, 2006, 7:25 pm
by Grant888
Title says it all, will the power window switchs from a 92rs work in my 92gs?
..sorry if this is a "complete yes" i'm new and dont knoew much about all of this.
thanks Grant
Posted: January 2nd, 2006, 10:21 pm
by FlyVFR
The ETM shows only one diagram so I would say yes.
Posted: January 3rd, 2006, 7:38 pm
by Grants
Yes - same year so ok.
Posted: January 5th, 2006, 1:34 am
by 93_mx3_gs
Depends if the harness is running into the door, if not..it will be a pain in the butt. If you can find a junker with power options, try to get the door off and the harness out of the door that runs into the cab. I think it goes to the side of the fuse block/box. Maybe not i'm not sure. THis only needs to be done if you don't have the harness.
Posted: January 6th, 2006, 11:08 pm
by FlyVFR
93_mx3_gs wrote:Depends if the harness is running into the door, if not..it will be a pain in the butt. If you can find a junker with power options, try to get the door off and the harness out of the door that runs into the cab. I think it goes to the side of the fuse block/box. Maybe not i'm not sure. THis only needs to be done if you don't have the harness.
I thought the question was about the switch
Besides all switch assemblies I have seen have a quick disconnect. Which can easily be separated from the wire harness after removing the screws that hold the assy. in the door panel.
Posted: January 7th, 2006, 10:43 am
by Slade
I have a switch for sale, but its from a newer than a 92 I think, it has the auto option on it.