MX-3.com

What you guys think....just an Idea I had.



Personally I think it's fire

It's nice. Hope the bumper becomes smaller, so you can drive on it.

Nice design, but its way to big. Wouldn't wanna drive that around, need a lift kit.

thats the BC2 front i have that. Looks alot nicer with the holes on the sides. All you need to do is add some wire mesh in there like I did with some fog lights. =)

i would remove those pieces along the side that make it look gayzor not the holes that make it look rad

Mr. Plow
Looks better with the holes on the sides. Don't like the round fog light holes, though.

extend the holes u got rid of inwards to remove the foglight holes and remove the side pieces and higher it so u can drive it and i'd say pretty fine dandy

me likes alot!

how much do you have the car lowered? my bc2 front had plenty of clearance.. i like taking those holes out... looks kinda cool

i think it looks nice w/out the foglight holes.

The car looks great, maybe raise it just a notch and you should be good to go.

So you manufactured that yourself? Good work!

See this is what it looks like when you get it all done.



I used a lot of wire and hot glue to put all the wire mesh on. =)

That's the stuff baby! Looking good.

You could use bondo and just dap it onto the rear of your bumper to secure the wire mesh next time, it's a lot easier and lasts a lot longer hehe.

i love that front bumper but it was sucha pain how low it was stock cause it was constantly scraping it on bumps and driveways and such

Thats why you have to go at angels to get out and take bumps slow. I am going to be lowering my car.... So there are going to be places i will not be ABLE TO GO ANYMORE!!!!!