MX-3.com

I'm finally starting my turbo project (it only took a year to start! )
and I need an idea how to do it. Does anyone have pics of their intercooler setup? I have a 6"x24" intercooler with a 2.5" inlet. Any help would be greatly appreciated. I have to get this done by the end of the summer!

what engine do you got ? I got pics for a K serie engine if you want

That is exactly how I did mine. I even have the MS Front too.

Sorry, I have a 1.6 L DOHC (1995). Do I have to cut through the frame where the power steering fluid is (underneath it)? Thanks again for the help!

no you don't have to. I manage my way around it..it's the same regardless if you have a v6 or 4

Mine is run mostly the same as everyone else's. However...I used 1G eclipse piping as I got it for free!! Works great. I also used the metal flange from a 1G to mount my BOV on.

Ryan, is there a lot of stress on that power steering piping having it pulled way up from where it normally sits? (which would be around right in front of the intercooler)

i know this is kinda a really lazy a-- question, but would neone be nice enough to say how many of each kinda bend they used for their set up? im trying to get the pipes together so i can get my new FMIC in and i dont wanna buy a buncha extra stuff if i dont have to...soo....pweez

how did you guys lead the piping around the engine to the manifold?

I think Someone who's done a successful turbo should put a "how to" up?
unless there already is one...

I think Someone who's done a successful turbo should put a "how to" up?
unless there already is one...