Page 1 of 1
Looking For MSD Distributor
Posted: February 22nd, 2005, 4:36 pm
by drftking
Im looking to upgrade my ignition system and i would like to go with msd. The only problem is i cant find one for our cars. I would like to the distributor and ignition. Any advice would be greatly appreciated.
THX
Posted: February 22nd, 2005, 5:03 pm
by DavidOS
gotta do the external coil swap thingy and get a msd 6a box it hink and hook it up?? ... i think im not sure as i havnt done the swap yet but do have the distributor ready for a msd swap.
Posted: March 1st, 2005, 1:11 pm
by bubba_03
I have a full MSD setup for my ZE. I got the brain from autozone and the Distributor cap from Probemotorsports.com. You have to remove a few things from your stock distributor to convert from internal to external coil. Probetalk.com is where I found alot of great info.
Posted: March 1st, 2005, 11:03 pm
by babyblueMX3
anybody using the ze 7 nipple disty ?
Posted: March 7th, 2005, 8:33 pm
by Chopperpozz
u can use the ze disty and run msd.. i have the diagram to do it but u will have problems with your stock tach stopping at around 6000. but i use an aftermarket tach anyways so it doesn;t bother me.. e-mail me if u want the diagram
chopperpozz@hotmail.com
Posted: March 7th, 2005, 9:48 pm
by papa roached
some might need the tach converter thing, or a 100K (is that teh right resistance?) ohm resister hooked between the signal wire on the stock harness and the negative side of the coil
Posted: March 7th, 2005, 9:52 pm
by Chopperpozz
i was running a 1k resistor and had problems with the stock tach.. just running it right off the msd tach output and no problems
Posted: March 7th, 2005, 10:26 pm
by babyblueMX3
hey chopper send that diagram to
steve_racine17@hotmail.com if you have time.
Thanks
Posted: March 8th, 2005, 6:28 pm
by Chopperpozz
e-mail sent
Posted: March 8th, 2005, 10:07 pm
by babyblueMX3
thanks got it