Page 1 of 1
what's a good route for wiring??
Posted: March 30th, 2004, 7:14 pm
by Bundy
I am doing the power window mods on my RS and need to pull some cables from here and there. I need 12v, Gnd, and some from the passenger's side door. My question is if you know the good route to pull the cable especially around the door hinge. Also, if I pull ones from the passenger's side door, where is a good place or route to pull cable?
bungo
Re: what's a good route for wiring??
Posted: March 30th, 2004, 7:16 pm
by lakersfan1
Don't you already have the rubber sleeve connecting the door to the frame?
Re: what's a good route for wiring??
Posted: March 30th, 2004, 7:18 pm
by SE-Man
best bet is to find one in the JW that has PW, and use the rubber molds and it will give you a good Idea of were to make the holes to run the wires.
Re: what's a good route for wiring??
Posted: March 31st, 2004, 2:38 pm
by Bundy
Can you telle me what you mean by "JW" and "PW"?
bungo
Re: what's a good route for wiring??
Posted: March 31st, 2004, 3:33 pm
by lakersfan1
Originally posted by Bundy:
Can you telle me what you mean by "JW" and "PW"?
bungo
I think he meant 'junkyard' and 'power windows'.'