Page 1 of 1
Idle at 5000rpm after swap
Posted: November 26th, 2003, 6:46 pm
by Etienne Daoust
I've jsut got my car rerereswapped, but this time it's with a j-spec curved neck intake, and when we start the engine, it revs right to 5000rpm and stick there. Does anybody knows what's the problem?
Re: Idle at 5000rpm after swap
Posted: November 26th, 2003, 7:16 pm
by IanL
I know its rather obvious, but its not the throttle linkage, is it?
Re: Idle at 5000rpm after swap
Posted: November 26th, 2003, 7:25 pm
by Etienne Daoust
no it's not. I'm actually getting my swap done by my local Mazda dealer and nobody's looks like knowing the problem!
Re: Idle at 5000rpm after swap
Posted: November 26th, 2003, 8:33 pm
by Etienne Daoust
no it's not. I'm actually getting my swap done by my local Mazda dealer and nobody's looks like knowing the problem!
Re: Idle at 5000rpm after swap
Posted: November 28th, 2003, 1:05 pm
by Etienne Daoust
For your info, it was a broken TB valve pin that wasn't allowing the valve to close tight.
I had another TB but it was coming from a long neck klze intake, while this was a curved neck, so it didn't fit eather. So we swaped the broken pin from the two TB and now it's working fine
Re: Idle at 5000rpm after swap
Posted: November 28th, 2003, 3:48 pm
by Zoso124
Massive Air Leak