Page 1 of 1
Swap question
Posted: October 16th, 2002, 7:11 am
by zevirii
When doing the swap, do you have to pull the tranny too?<P>I was thinking of just putting a few blocks under the tranny, unbolting it and then pulling the engine.. This way I don't have to mess with the axles..<P>What you guys think?
Re: Swap question
Posted: October 16th, 2002, 9:12 am
by David Coleman
Pull it all as one unit. Much easier. [img]shrug.gif"%20border="0[/img]
Re: Swap question
Posted: October 16th, 2002, 2:16 pm
by zevirii
Can you do it that way though?
Re: Swap question
Posted: October 16th, 2002, 7:33 pm
by lazzyie
id follow the book on that one! Cause putting it back in with the tranny already there would be a biatch!
Re: Swap question
Posted: October 16th, 2002, 9:12 pm
by curtklze
Pull it with the trans,<P>when you put it back in, dont put on the harmonic balancer, it will get caught on a metal tab on the right side of the engine compartment.<P>if you leave off the balancer it will go in easy with a friend to help.