Page 1 of 1
Millenia ZE intake manifold vacuum line question
Posted: July 24th, 2002, 1:25 am
by David Coleman
So my ZE manifold has the VRIS solenoids bolted to the manifold, side by side. the one closest to the TB has a white sticker on it, and the other one doesnt. Any idea which goes to which plug on the stock harness?
Re: Millenia ZE intake manifold vacuum line question
Posted: July 24th, 2002, 2:47 am
by David Coleman
An answer from Tom [precidian]:<P>
<BR>
<BR>
Re: Millenia ZE intake manifold vacuum line question
Posted: July 24th, 2002, 3:41 pm
by ZUNE MX-3 Gs
I would connect it anywhere and run the engine. The Vris program may be similar to the regular Kl one, so looking at what valve opens first you could know what is valve nº1 and valve nº2. I suppose that the only difference are the opening points on the powerband, but the sequence should be the nearly the same.
Re: Millenia ZE intake manifold vacuum line question
Posted: July 24th, 2002, 3:57 pm
by David Coleman
Nah, I'll just stick with getting it right the first time
Re: Millenia ZE intake manifold vacuum line question
Posted: July 25th, 2002, 1:46 am
by ghandi1981
hey david which manifold are u using??? is that like the one i saw on ebay the other day???<P>AJ
Re: Millenia ZE intake manifold vacuum line question
Posted: July 25th, 2002, 1:50 am
by Smokin mx-3
I have this exact same manifold and I have the white connector with the white dot<BR>the same way it is in the picture <BR>it runs fine
Re: Millenia ZE intake manifold vacuum line question
Posted: July 25th, 2002, 8:56 pm
by David Coleman
<BLOCKQUOTE><font size="1" face="Verdana, Arial">quote:</font><HR>Originally posted by ghandi1981:<BR><STRONG>hey david which manifold are u using??? is that like the one i saw on ebay the other day???<P>AJ</STRONG><HR></BLOCKQUOTE><P>Curved neck Millenia manifold. Just like the one above.