Page 1 of 1
how to run cables from engine bay?
Posted: April 17th, 2002, 12:10 pm
by Sparky75
Im putting an alarm and a sub in my MX-3 V6,<BR>wheres the best location for the alarm and where can i run the wiring?? cheers.
Re: how to run cables from engine bay?
Posted: April 17th, 2002, 12:15 pm
by Sonicxtacy02
most people put the brain to the alarm where the ecu is (down by your right leg, remove the panels there). As far as running the wires to the battery, there is a rubber circular grommet that sits on teh firewall. If you look down behind the dash on the drivers side you will see it up and towards the left. You can also see it in the engine bay. Just poke it through and run your wires through there. Be sure to wires along the firewall and not in front of the pedals etc.