MX-3.com

new to the site but not to cars.... ive swapped numerous honda motors but i would like to swap a BPT-GTR/GTX into my stock 1.6L DOHC 4cyl. im looking for a package deal or at least somewhere where i can buy most of these following items.... (give or take a few) tranny, axels, ECU, Performance Clutch, Blow Off Valve, Fuel Pump, Custom intake, Custom intercooler, Water temp. and Oil pressure guages, A'PEXi S-AFC". the problem i have been running into is that i am gonna need alot of extras such as these important items. i would rather buy a partial or full package motor deal. if i dont get a package its gonna be off the road too long and it will cost more (to buy parts piece by piece not to mention finding them.) i live in the states (east coast). thanks for your time! if anyone knows of where i could get a package deal your help would be greatly appreciated!

Ok,

The Mx-3 does not have near the aftermarket support that a typical honda does, so a package deal is probley out of the question. Unless you could find someone selling all the stuff ya need which is doubful. I would sugest visiting this web site they have a lot of parts for the swap.
And do a search on the board it will anser many questions you may have.

Peace; Gary

what ecu are you hoping to use?

im not sure what ecu would be best for the bpt?! what do u guys think? i think my best bet would to be try and find a full front clip. it may be a little more but then i wont get nickel and dimed to death.

ok, that's my point. you can't use another ecu unless you use the other harness. this is a pain and not worth it at all. unfortunately, the easiest and most beneficial solution for dohc mx3's is a standalone system.

or bolting on an b6t manifold & turbo.......

I dont know of anyone running the bpt on the dohc

i was, jaydog and natural born honda killer are.

For pics of Justin's Engine--

Go here:

http://www.atlantamx3.com/moca/justin

For a detailed "Shopping list" & swap process on how to swap the BPT into a 1994 RS, go here:

http://www.atlantamx3.com/mocaforum/viewforum.php?f=6

He has a 1994 MX-3 RS and has successfully swapped the BPT in.

He is putting down 204 HP & 210 Ft Lbs of Torque to the wheels.