MX-3.com

Multipe Spark Distribution, that is how my broblem is called , i just bought a MSD Ignition Control a (6AL) and i have no real idea about instaling it. I kind of have an idea but the directions that came with it aren't specific for the MX-3. I have to ask you guys for help, any information about it's instalation would be helpful, If u know how to hook this up to a 93 4cil SOCH MX-3 , than email me at plusinfinit@yahoo.com
Thanks.

OK stuff you need:
MSD Coil: Get a matching coil(blaster2) so the new ignition can do its job. $35
MSD Coil bracket: you need to hang the coil with something. $5
MSD Tach adapter: MSD P/N 8910. $25

MSD:
thick red - Pos batery
thick black - Neg batery or ground
red - Ignition switch. thick BLU wire. tap do NOT cut
orange - coil+
black - coil-
white - GRN/WHT wire going to the igniter on the stock coil bracket.

Tach Adapter:
white: You need to run a new tach wire See Below
Red: Put in between switched wire and MSD red wire

Tach wire:
1. Take all the screws out of from under the steering column
2. Remove the bottom and top plastic pieces for the column
3. Take the 3 screws out of the top of the gauge trim and remove it
4a. Remove the 4 screws holding in the cluster and tilt it to the side
4b. Grab the speedo cable and squeeze the clip and pull out *don't move the car
5. Find the blue/yellow wire and clip it
6. Run new wire from the tach plug BLU/YEL to the MSD
7. Splice the GRN/WHT and the new tach wire together then connect to the tach adapter
8. Connect MSD to the tach adapter.
9. Test the tach by starting car *don't drive it
10. Reassemble everything and remember the speedo cable!

This should get you running.

<small>[ November 19, 2003, 01:20 PM: Message edited by: RiceRocket666 ]</small>

I have a real good how to on the MSD SCI-L which is pretty much the same I will email it to you if you want. Also keep an eye on ebay I will be selling my Tach Adapter which is almost new and other stuff since I went another route on my setup.