bpt swap and a/c
Posted: April 21st, 2003, 2:50 am
If I do the bpt swap can i keep my a/c?
MX-3.com
The Worlds First and Largest Mazda MX-3 Forums
https://www.mx-3.com/phpbb3/
bpt swap and a/c
Page 1 of 1
Re: bpt swap and a/c
Posted: April 21st, 2003, 9:43 pm
yes cause i cant live without a/c in dallas. too hot. but yes its capable of having a/c with the bpt in the mx-3.
Re: bpt swap and a/c
Posted: April 21st, 2003, 10:23 pm
aye it is possable. The only problem you will run into is intercooler sizing, but if you dont mind doing about a days worth of cutting and sanding to your bumper support anything will fit. I fit a 18x9x3(core) IC behing my stock nose and still have my support relitivly intact. One last thing, if you have the power steering fluid cooler(the hoop of tubing in front) just remove the brackets and tuck it behind the support for the hood latch. It isn't pretty but you'll never see it anyway.<p>[ April 21, 2003: Message edited by: RiceRocket666 ]</p>
Re: bpt swap and a/c
Posted: April 22nd, 2003, 2:39 am
Bah who needs ac =]
Re: bpt swap and a/c
Posted: April 22nd, 2003, 10:41 am
what's a/c 
Re: bpt swap and a/c
Posted: April 22nd, 2003, 1:37 pm
The biggest problem that you will have is downpipe sizing as it is difficult to produce a 3" downpipe and still clear the a/c. Of course this all depends on how you orientate the turbo.
Re: bpt swap and a/c
Posted: April 22nd, 2003, 2:16 pm
ok Ash, wait till FL starts to heat up again. Even though it make my car slower than *beep*, ill take that then burning up down here
Re: bpt swap and a/c
Posted: April 23rd, 2003, 2:52 pm
wait it gets hot in florida??!?!?!? I figured i would move there so i could live in a colder climate..