MX-3.com

freaking awesome man! Great paint job. Picking up the set up this weekend. I'm so going to do my whole car! Thanks!

Vecia wrote:freaking awesome man! Great paint job. Picking up the set up this weekend. I'm so going to do my whole car! Thanks!

It's soo easy to do. Keep in mind, the cost for the whole car I was quoted 300-$600 pending on the quality of the paint. I plan to do the whole car as well. I am thinking about adding an intake and exhaust filter/flow system in the garage wall to limit fumes and dust.

Best of luck. Try to start small to get your gun set up.

RS_OBD'oh_2 wrote:rear strutbar added. It's now known as the car with many bars

Looks like I will have to remove the B pillar bar to make way for the baby seat (in the near future.)

Dibs given to Mike, if he wants it.

RS_OBD'oh_2 wrote:

RS_OBD'oh_2 wrote:rear strutbar added. It's now known as the car with many bars

Looks like I will have to remove the B pillar bar to make way for the baby seat (in the near future.)

Dibs given to Mike, if he wants it.

really? i think it'd fit lol.
why don't you just keep it for later when she's grown up and sitting in the front seat with you? daddy daughter cruise's XD

Use it to dangle teddy bears & other soft toys from, keep her entertained in the car!!

ethand wrote:Use it to dangle teddy bears & other soft toys from, keep her entertained in the car!!

LOL! best idea ever

RS_OBD'oh_2 wrote:New (to me) hood installed. Thanks Chris.

I'm a bit late to the party here, but did you make custom holes to fit your hood pins or did they fit in a hole that was already there?

I like you're car by the way.

I like the stuffed toy idea. It would totally work.

The hood was used, but the pins were in perfect position to line up with existing holes in the front support.

RS_OBD'oh_2 wrote:I like the stuffed toy idea. It would totally work.

The hood was used, but the pins were in perfect position to line up with existing holes in the front support.

I realize that I may have not made sense, I was asking wether the pins slid into existing holes.
I'm gonna put in two more support holes and I'm thinking of putting them right were you have yours, are the holes in the actual frame or are they in something else?

RS_OBD'oh_2 wrote:I like the stuffed toy idea. It would totally work.

Booyeahhh!! I'm full of good ideas!! Haha... that was honestly the first thing I thought when I saw the position of it lol.. You can tell I have little nephews

RobMinhas wrote:I'm gonna put in two more support holes and I'm thinking of putting them right were you have yours, are the holes in the actual frame or are they in something else?

I mounted mine to what sounds like the exact same thing as RS_OBD'oh_2 where I put them in existing holes on the support, and I much perfered them (for looks and function) on the sides of the hood rather than in the center.

new stuff. May take a couple days to get installed

Vac block (thanks mike) Mishimoto rad and power steering cans, batt terminals.. and a tie down that may need to be modified.

I've never seen that hood with a badge on it! I like it a lot better that way!

Your driveway looks like mine too, full of cars.

I think you should keep the pillar bar btw, dangling toys from it is just a bonus!

really interested to see how that stuff looks install in the engine bay

I am really looking forward to scrubbing the hole bay down. A little bling should add a nice touch.