MX-3.com

youdirtyfox wrote:OOhh shes nice!! Got the potential to be clean and classy Projectors are spoiling it for me a bit a little though

I have Euro spec lights to go on it

I'll take the projectors! haha
I would if they were black...

Took a few pictures this weekend She wont look like this for too much longer...

BTW - The AST coilovers... this is as low as they will go in the rears... the collars are only grabbing threads half way through. I lowered the car 1/4" in entirety all the way around, I was hoping for a full inch, oh well. I guess I could always pull out the helper springs

looks really clean. Keep us posted.

I love that MS emblem on the hood(wish I could do that also) !!! The whole car looks soo clean!!

She looks so pretty, I wouldn't change a thing!

"Clean" is an understatement. Really does make mine look like crap. The projectors look EXTRA shiny.

Picture from the other day...



Starting the repair on the MS spoiler, damage from shipping




The start of the Battery relo. I went to probably 5 different stores with copper cable and everyone wanted 7 to 9 dollars a foot. I said F that, I know copper has gone up but damn. I couldent seem to locate a place online to find what I wanted either. SO, was strolling through the Lowes and on the clearance rack found this... 25 feet 1 AWG gas and oil resistant direct burial copper wire... 15 bucks! Better than a 100 -140 dollar amp kit... Copper is copper and 1 awg is 1 awg, though it has fewer strands it will do the job just nicely.





Picked up a can of plastidip too

This weekend I will have the Spoiler, USDM sides and rear flaps painted

BTW Duplicolor sucks, they discontinued Mazda PT white... they say they still sell it in 5oz cans but no bueno. I found a ford color that is very similar but it is still off, I painted my rear mud guards with it and cant stand the minor difference. So to NAPA Paint for an 18 dollar pint of Mazda PT. Wesco, which is where I usually go for paint wanted 80 bucks for a pint...

My MS spoiler has a similar crack. Maybe it's due to shipping or due to incorrect installation. I noticed when I was installing mine that if I was off by a mm or 2 the crack stretched... Maybe you should repair it after you install it? I would hate for you to "fix" it and it splits open when installing...

Yeah, the spoiler was shipped to me from Japan wrapped only in plastic wrap... I am using epoxy vs fiberglassing it will have a little bit more give. I need to drill a couple holes in the ends of the cracks to stop it from going further.

Lookin' good. the spoiler shold be an easy fix.

DAdat







Dadat







Dadat






Dadat




Dadat


Dadat

Dadat
Dadat
Dadat
Dadat










Soon to come

subscribed

Yah buddy, best bumper out there.