Page 2 of 2
Re: computer swap
Posted: September 15th, 2011, 10:34 pm
by Ryan
Looks like this:
Re: computer swap
Posted: September 15th, 2011, 10:38 pm
by ftawizard
No ......
Re: computer swap
Posted: September 15th, 2011, 10:40 pm
by ftawizard
I have never taken the cover off it's a black place and says diagnostic on it it's behind the battery
Re: computer swap
Posted: September 15th, 2011, 10:42 pm
by Ryan
Yes, I know what that is, I'm asking you if you have this port in the cabin. It is the OBDII scantool interface. It must be within 2' of the driver, its located in the driver footwell.
Do you have it or not?
Re: computer swap
Posted: September 15th, 2011, 10:52 pm
by ftawizard
No I don't believe I do have it
Re: computer swap
Posted: September 30th, 2011, 1:42 am
by ftawizard
Ok I swapped ecu and harness back to original ..... Haveing a idle up and down issue and still no where to plug in the yellow four prong plug (smaller of the two plugs coming off fuel rail wire harness) .... As well as my harness only has one plug for a o2 sensor.....
One other thing can someone post a pic of where a egr position sensor is suppose to mount? Again it's a 95 mx3 4 cylinder 1.6 dohc please and thank you
Re: computer swap
Posted: October 11th, 2011, 1:15 am
by gxser
i would take that harness and the B6DE from the 96 you have ive been looking for one all summer!!!!
Re: computer swap
Posted: October 11th, 2011, 9:34 am
by ftawizard
Where abouts are u located I got the ecu and the harness