The Worlds First and Largest Mazda MX-3 Forums
https://www.mx-3.com/phpbb3/
sorry I wasnt clear, there is a predriled hole already there. b/c the 323, protege endlinks bolt through there.projectmx wrote:i'm confused you say they are bolt in like stock but these look only half like the stock ones... did you drill a hole into the front control arm to connect that part of the link up? or was there a hole already there? (i haven't looked closely at my CAs in a while so i can't recall offhand)
more info on the spherical bearing links you are selling please!!!wytbishop wrote:I am a little biased, obviously, but the big problem I have with stock replacement, and the reason I decided to build and sell the spherical bearing end links, is that they were nearly impossible to get off. Once they've had a few years to rust and corrode, they are very hard to get off. I also wanted something more rigid.
but for $20 this is a good alternative.
This thread contains the information you seek. I will be doing another round in a little while. I have a little too much going on right now.mx3autozam wrote:more info on the spherical bearing links you are selling please!!!wytbishop wrote:I am a little biased, obviously, but the big problem I have with stock replacement, and the reason I decided to build and sell the spherical bearing end links, is that they were nearly impossible to get off. Once they've had a few years to rust and corrode, they are very hard to get off. I also wanted something more rigid.
but for $20 this is a good alternative.